因交叉滾子軸承是薄壁小型結構，所以要充分考慮支承座或固定法蘭的剛性。（如下圖)當外圈是分割型時，如果支承座或固定法蘭及固定螺栓的剛性不足，就不能均等地固定內環或外環，在承受力矩負荷時軸承將產生變形，因此，滾子的接觸區域會變得不均勻,軸承的性能就會顯著地降低。

Because the cross roller bearing is a thin-walled small structure,the rigidity of the support seat or fixed flange should be fully considered.(As shown in the figure below)When the outer ring is a split type,if the rigidity of the support seat or fixed flange and fixed bolt is insufficient,the inner or outer ring cannot be fixed evenly,and the bearing will deform when bearing the torque load.Therefore,the contact area of the roller will become uneven,and the performance of the bearing will be significantly reduced.

以上就是文章的大致內容了，如果您有交叉滾子軸承、轉盤軸承相關的問題和需求，可以咨詢洛陽千協軸承，我們主營：交叉滾子軸承，轉盤回轉支承軸承，YRT轉臺軸承，等截面薄壁軸承等，支持非標定制，交期短，歡迎來電咨詢！

The above is the general content of the article.If you have problems and needs related to cross roller bearing and rotary table bearing,you can consult Luoyang Qianxie Bearing.Our main products include cross roller bearing,rotary table slewing bearing,YRT turntable bearing,equal-section thin-wall bearing,etc.,support non-standard customization,short delivery time,welcome to inquire!